KVR16LN11/8
8GB 2Rx8 1G x 64-Bit PC3L-12800
CL11 240-Pin DIMM
DESCRIPTION
This document describes ValueRAM's 1G x 64-bit (8GB) DDR3L-1600, CL11 SDRAM (Synchronous DRAM), 2Rx8, Dual voltage, memory module, based on sixteen 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V.
This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:
FEATURES
• JEDEC standard 1.35V (1.28V ~ 1.45V) or 1.5V (1.425V ~ 1.575V) Power Supply
• VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with starting address ?000? only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
• Bi-directional Differential Data Strobe
• Thermal Sensor Grade B
• Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ? 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85?C, 3.9us at 85?C < TCASE < 95?C
• Asynchronous Reset
• PCB: Height 1.18? (30mm), double sided component

SPECIFICATIONS
CL(IDD) 11 cycles Row Cycle Time (tRCmin)
48.125ns (min.)
Refresh to Active/Refresh . Command Time (tRFCmin) 260ns (min.)
Row Active Time (tRASmin) 35ns (min.)
Maximum Operating Power (1.35V) = 2.730 W*
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C